This is the 6 pin connector plug suitable for use with Discovery 3, Discovery 4 and Range Rover Sport suspension height sensors.
Often found at a very high cost on eBay but now available at a special price for forum members.
Available as a bare connector housing; or with loose terminals, seals and blanks supplied (3 of each); or with terminals and seals pre-wired to 3 repair wires (coloured blue, red and yellow) and three blanks.
When selected with the "With terminals/seals (x3)" or "With pre-wired terminals x3" option this connector can be used an alternative to Land Rover repair kit YMQ503220
Recommended colour code/pinout:
Red wire to Pin 1 (5V)
Blue wire to Pin 4 (Signal)
Yellow wire to Pin 5 (Ground)
We will pre-assemble orders with the "Pre-wired terminals" option to the above colour code and fit blanks in positions 2, 3 and 6.
As the colour code on the vehicle loom varies on each corner, use the following table as a cross reference:
| Sensor | Pin 1 (Red) | Pin 4 (Blue) | Pin 5 (Yellow) |
|---|
| Right hand (front and rear) | Grey with Red (SR) | Grey with Blue (SU) | Grey with Yellow (SY) |
|
| Left hand front | Grey with Black (SB) | Grey with Orange (SO) | Grey with Green (SG) |
| Left hand rear | Orange with Yellow (OY) | Orange with Red (OR) | Orange with Black (OB) |
Land Rover part number for reference only: YPC909530 (bare connector)
Electrical reference numbers: C1696 / C1697 / C1698 / C1699
